NitroData Chip Tuning Box for Motorbikers M2 Hot Sale

As some motorcycles run richer and others are leaner, we suggest that you start by using the NitroData with the dial set to minimum and gradually increase the dial to a higher until you find the setting which is best for your bike. A slightly modified engine (sport exhaust, air filter etc.) will generally a better performance with the dial set around midle if the bike has an aftermarket exhaust system fitted. A setting between midle and midle more can be used

When the catalytic converter has been removed. The original standard performance is to be found at minimum setting on control unit.

If the bike running richer then the setting will probably need to be set between litle then minimum. You will feel from the performance of the motorcycle when the engine is running smoothly and it is not necessary to run a Dyno test. Please avoid falling into the trap of thinking the higher the maximum the better the performance as it will vary depending on the bike. If it appears that you are losing the torque when you hit high speeds this most probably means that you have set the NitroData number too high and need to try a lower setting.

To fit the NitroData you will need to locate the air temperature sensor (IAT) which is located near the air box on most bikes.Disconnect the plug connectors which are already attached to the IAT and attach the plug connectors of the NitroData module to the relevant connector of the IAT. The NitroData is now ready to use.

Please check the technical service which next to the description.

NitroData Chip Tuning Box for Motorbikers M2 vehicle list:

Aprilia RSV 1000 / Tuono 04-08

Aprilia RSV 1000R Factory 04-08

Aprilia Tuono 1000 / Tuono 04-08

1pc x NitroData Chip Tuning Box M2