STC SVCI DoIP

If you want to use the SVCI DoIP device normally, you have to download and install three software, they are Pathfinder, SDD2 and SDD2 "QuickLoader" software. These three software can be installed in the same operating system together, and when you use SDD2 software, you have to open it from the SDD2 "QuickLoader" software. And when the software is installed, the device needs to be connected to the laptop and vehicle. The Pathfinder software is primarily intended for Jaguar Land rover models manufactured in 2017 and beyond, The SDD2 software is mainly aimed at Jaguar Land rover 2016 years models and before.

Step 1: Before installing the software, you need to make sure the C drive has a capacity of more than 250GB.

Step 2: Access to software download center http://www.flyOBD.com/shop/download-center/

Step 3: Selection “Pathfinder” item and download pathfinder installer

Step 4: Double-click the file that you download and saved, and then install it.

Step 5: The pathfinder installer will automatically prompt you to download and update the software and files you need to install pathfinder(The automatic download and installation will takes up to 24 hours according to network download speed).

Step 1:Download software from http://diagnosticdelivery.jlrext.com/idscentral/

Step 2:Selection the “SDD_xxx_Full.exe” file, download and save it.

Step 3:Double-click the “SDD_xxx_Full.exe” file and install it.

Step 4:Selection SDD2-"QuickLoader" item from http://www.flyOBD.com/shop/download-center download and install it.

Step 5:Double-click the “SDD2 "QuickLoader".exe” file and install it.

2.2 Connected devices

After installing the software, you need to connect the equipment to the computer using a USB cable. Then connect the OBD interface of the vehicle through SVCI DoIP device, or connect the OBD interface of the vehicle and the equipment through the OBD extension cord. The equipment connection diagram is shown below.